ZyXEL Communications AMG1001-T Series User Manual page 117

Where "i" specifies binary image transfer mode (use this mode when transferring binary files),
"host" is the device's IP address, "put" transfers the file source on the computer (firmware.bin –
name of the firmware on the computer) to the file destination on the remote host (ras - name of the
firmware on the device).
Commands that you may see in GUI-based TFTP clients are listed earlier in this chapter.
Using the FTP Commands to Back Up Configuration
Launch the FTP client on your computer.
1
Enter "open", followed by a space and the IP address of your AMG1001-T/AMG1011-T.
2
Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "1234").
4
Enter "bin" to set transfer mode to binary.
5
Use "get" to transfer files from the AMG1001-T/AMG1011-T to the computer, for example, "get
6
rom-0 config.rom" transfers the configuration file on the AMG1001-T/AMG1011-T to your
computer and renames it "config.rom". See earlier in this chapter for more information on
filename conventions.
Enter "quit" to exit the ftp prompt.
7
FTP Command Configuration Backup Example
This figure gives an example of using FTP commands from the DOS command prompt to save your
device's configuration onto your computer.
Figure 74 FTP Session Example
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
AMG1001-T/AMG1011-T Series User's Guide
Chapter 22 Firmware
117