The Ip Address Mapping Screen - ZyXEL Communications AMG1001-T Series User Manual

Table 24 Advanced Setup > NAT > Virtual Server
LABEL
Start Port
Number
End Port Number
Local IP Address
Virtual Server Listing
Rule
Application
Protocol
Start Port
End Port
Local IP Address
SAVE
DELETE
BACK
CANCEL

10.5 The IP Address Mapping Screen

Configure this screen if you have multiple IP addresses from your ISP and you want to map them to
private IP addresses on your LAN.
Note: The Address Mapping screen is available only when you select Multiple for the
Number of IPs in the NAT screen.
Ordering your rules is important because the AMG1001-T/AMG1011-T applies the rules in the order
that you specify. When a rule matches the current packet, the AMG1001-T/AMG1011-T takes the
corresponding action and the remaining rules are ignored.
AMG1001-T/AMG1011-T Series User's Guide
DESCRIPTION
Enter a port number in this field.
To forward only one port, enter the port number again in the End Port Number field.
To forward a series of ports, enter the start port number here and the end port number in
the End Port Number field.
Enter a port number in this field.
To forward only one port, enter the port number again in the Start Port Number field
above and then enter it again in this field.
To forward a series of ports, enter the last port number in a series that begins with the
port number in the Start Port Number field above.
Enter the inside IP address of the server in this field.
This is the rule's index number.
This is a service's name.
This is the IP port.
This is the first port number that identifies a service.
This is the last port number that identifies a service.
This is the server's IP address.
Click this to save your changes.
Click this to remove the rule.
Click this to return to the previous screen without saving.
Click this to restore your previously saved settings.
Chapter 10 Network Address Translation (NAT)
69