Static Ip Address - ZyXEL Communications AMG1001-T Series User Manual

Chapter 7 Internet Setup

7.2.2 Static IP Address

In the Interface Setup > Internet screen, select Static IP Address from the ISP field to display
the following screen.
Figure 23 Interface Setup > Internet (Static IP)
The following table describes the labels in this screen.
Table 13 Interface Setup > Internet (Static IP)
LABEL
Encapsulation
Static IP Address
IP Subnet Mask
Gateway
Bridge Interface
NAT
Default Route
TCP MTU Option
Dynamic Route
44
DESCRIPTION
Select the method of multiplexing used by your ISP from the drop-down list box.
Available options are: 1483 Bridged IP LLC, 1483 Bridged IP VC-Mux, 1483
Routed IP LLC(IPoA) and 1483 Routed IP VC-Mux.
A static IP address is a fixed IP that your ISP gives you. Type your ISP assigned IP
address in the field.
Enter a subnet mask in dotted decimal notation.
Specify a gateway IP address (supplied by your ISP).
This field is only available when you select 1483 Bridged IP LLC or 1483 Bridged IP
VC-Mux in the Encapsulation field.
Use this field to enable or disable the bridge mode. Activate the bridge mode when your
ISP provides you with more than one IP address and you want the connected computers
to get individual IP address from ISP's DHCP server directly.
Use this field to enable or disable Network Address Translation (NAT).
Select Yes to direct traffic not listed in the routing table to the default gateway. Select
No to drop traffic not listed in the routing table.
The Maximum Transmission Unit (MTU) defines the size of the largest packet allowed on
an interface or connection. Enter the MTU in this field.
RIP (Routing Information Protocol) allows a router to exchange routing information with
other routers.
Select the RIP version from RIP1, RIP2-B and RIP2-M.
AMG1001-T/AMG1011-T Series User's Guide