Adjusting The Touch Panel - Mitsubishi Electric AG-150A Instruction Book

10-3 Adjusting the touch panel

To adjust the touch panel, touch [Maintenance] on the setting change screen and then [Touch Panel Calibration] to bring up the Touch
Panel Calibration screen.
Note: The use of any commercially available touch pen is recommended.
Start calibration
button
The touch panel calibration screen will appear when the [Start Calibration] button is touched.
A white "5 dots × 5 dots" square will appear in the screen in the following order: left top, center top, right top, left middle, center, right
middle, left bottom, center bottom, and right bottom. Every time the square is touched, the next square will appear. When all nine
squares are touched, calibration is complete, and the display will return to the touch panel calibration screen. If the screen is left
untouched for one minute, the display will automatically return to the calibration screen, and this step needs to be started over.
* The screen may not be calibrated properly if touched with a finger. Use a pointy but not sharp object to touch the screen.
* A sharp object may damage or scratch the screen.
– 87 –