Maintenance Screen; Copying The Data To A Usb Memory - Mitsubishi Electric AG-150A Instruction Book

10. Maintenance screen

10-1 Copying the data to a USB memory

Note:
•
The table below shows USB memory devices that have been confirmed to work. (As of October 2010)
No. Manufacturer
1 Sandisk
2 kingston
3 I/O data
4 I/O data
5 BUFFALO
6 BUFFALO
7 BUFFALO
8 BUFFALO
9 adata
* Asterisks in the Model column describe colors.
Do not make a security function setting when using No.10, 12, 13, or 14.
•
If any USB memory above cannot be obtained, use a memory device that meets the following three conditions. Test the memory
device several times before use and verify that the device functions properly.
Reading data from or writing data to a memory device that has not been confirmed to work may cause unexpected problems.
Make sure to test the memory device before operating the unit (during the test run). Do not use a memory device that has
experienced writing error once.
To copy the data to a USB drive, plug the USB into a USB port, and touch [Data Utility] in the screen that appears when [Maintenance] on
the setting change screen is touched.
1Initial
settings
button
3Charge
parameters
button
5Read from USB
memory button
Item
1Initial settings
Setting data
2User Info
Model
SDCZ6-2048-J65RB
DT400/2GBFE
TB-BH2/2G/*
TB-BH2/4G/*
RUF-C2GS-**/U2
RUF2-C2GS-**/M
RUF-C4GS-**/U2
RUF-C8GS-**/U2
C702
1 USB standard: Verified with USB 1.1
2 Format type: Must be in FAT32 or FAT (FAT16) format
3 Security function is not provided, or not required to set.
USB port
Touch the button to select, and touch again to deselect.
With the button selected, touch the [Copy to USB Memory] button to copy all settings data
(except the AG-150A user information), to the \[Serial Number]\[SettingData] folder in the
root folder of the USB memory. If the folder does not already exist, one will be created.
* The type of settings that cannot be set on the LCD screen, such as the energy-save
setting data, will also be copied.
Touch the button to select, and touch again to deselect.
With the button selected, touch the [Copy to USB Memory] button to copy the AG-150A user
information to the \[Serial Number]\[SettingData] folder in the root folder of the USB
memory. If the folder does not already exist, one will be created.
* The data can be copied only when logged in as the Maintenance User.
Capacity No. Manufacturer
2G 10 Verbatim
2G 11 SILICON POWER
2G 12 ELECOM
4G 13 Transcend
2G 14 TDK
2G 15 BUFFALO
4G
8G
2G
Description
– 82 –
Model
USBM4GVWS1
SP002GBUF2M01V1*
MF-NU2A04G**
TS2GJFV33
UFD4GS-T*A
RUF2-K4GE-**
2User Info button
4Power
consumption data
button
6Copy to USB
memory button
Capacity
4G
2G
4G
2G
4G
4G