Mitsubishi Electric AG-150A Instruction Book page 29

Function
4 Set Air Direction Set the air flow direction
with the Up/Down
arrows below "Air
Direction" function.
5 Fan speed Use the Up/Down
arrows below "Fan
Speed" function to set
the fan speed.
6 Prohibiting local Press the button that
remote controller corresponds to the
operation desired function and
setting to permit or
prohibit the operation
from the remote
controller. The functions
that can be prohibited
are: ON/OFF, operation
mode, temperature, and
filter sign reset.
7 Filter sign reset Press "Reset" under
"Filter Sign".
8 Ventilation ON/ Select the ON/OFF
OFF status for the interlocked
unit.
9 Ventilation Fan Set the fan speed with
speed the Up/Down arrows
below "Fan Speed".
0 OK Press the OK button to
reflect the change.
a Cancel Press the Cancel button
to cancel the change.
* The change on the interlock setting between the indoor and LOSSNAY units made on the indoor unit side will not be reflected on the
LOSSNAY unit side on the screen until the OK is pressed and the change is saved. The actual interlock setting, however, is
immediately effective, so as soon as the interlock setting on the indoor unit side is set to ON, the LOSSNAY unit will go into operation
when one or more indoor units go into operation regardless of the display on the screen.
Operation method
5-directions model
(Swing and Auto are not available on some indoor unit(s). Depending on the indoor
unit four or five air flow directions are available.)
4-speed model:
("Auto" is not available on some indoor units. Some indoor units of units have only
two or three fan speeds.)
Pressing of each button toggles through the following three options:
Retention of current status → Permit → Prohibit
Operation mode
Filter sign reset
Filter cleaning warning sign will be removed. Filter cleaning schedule time is reset.
An orange frame will appear around the selected operation status.
2-speed model:
(Fan speed setting is not available on some indoor units.)
Pressing the OK button saves the setting and takes the screen back to the previous
screen (Floor layout or Block display).
Pressing the Cancel button cancels the change and takes the screen back to the
previous screen (Floor layout or Block display).
(Mid 3) (Mid 2)
(Swing) (Auto)
(Low)
(Auto)
Leave current
status as is
ON/OFF
Temperature
setting
(Low)
– 28 –
Display
(Mid 1) (Mid 0)
(Mid 2) (Mid 1)
Permit
(High)
(Horizontal)
(High)
Prohibit