J. Install Trim
•
Install optional trim kits and/or surrounds using the
instructions included with the accessory.
•
Use non-combustible materials to cover the gap between
the sheet rock and the appliance (if desired).
•
Do not obstruct or modify the air inlet/outlet grilles.
•
Leave space to lower the bottom grille and remove the
trim door.
K. Install Clean Face Components
Carefully remove components from skin pack. See Fig-
ure 14.9 for identifi cation of components.
Figure 14.9 Clean Face Components/Skin Pack
Install Hood
•
Bend screen rod tabs down at a 90-deg. angle. See
Figure 14.10.
Figure 14.10 Screen Rod Tab
32
Heatilator • Caliber Mesh BV Series • 4040-848 Rev G • 10/08
•
Install above the glass panel.
•
Hood must be attached or a fi re hazard may result.
•
Locate the four screws (for 4236) or fi ve screws (for
4842) just inside the upper section of the appliance.
•
Loosen the screws, but do NOT remove.
•
Position hood and slide notches over screw heads,
ensuring hood also slips into the clips.
•
Tighten the screws to hold hood fi rmly in place.
•
See Figure 14.11.
Figure 14.11 Installing the Hood
Install Top Latch Cover
•
Insert top latch cover over existing shoulder screws.
See Figure 14.12.
•
Push down until the tabs lock in place.
Figure 14.12 Installing Top Latch Cover