H. Install the Log Assembly
•
Base logs have been permanently mounted on the grate
assembly and should not be moved. See Figure 14.5.
Figure 14.5 Base Logs
•
Install "Y" log on left hand side of grate using locating
pins to position. See Figure 14.6.
Figure 14.6 Placing Left Top Log
•
Install right top log as shown in Figure 14.7 using locating
pins to position log properly.
Figure 14.7 Placing Right Top Log
Heatilator • Caliber Mesh BV Series • 4040-848 Rev G • 10/08
I. Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
•
DO NOT strike, slam or scratch glass.
•
DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
•
Replace as a complete assembly.
Removing Glass Assembly
•
Remove mesh fi rescreen (refer to Figure 14.15).
•
Lift and pull the upper latch cover towards you to expose
the two (36 in. model) or three (42 in. model) glass
latches.
•
Lift and pull lower latch cover to expose the two (36 in.
model) or three (42 in. model) glass latches.
•
Rotate the bottom of the screen assembly away from
the appliance and lower out of the top retainers.
•
Release the top and bottom access latches and rotate
the top of the glass assembly away from the top of the
appliance.
•
Place the glass assembly on a surface that will not
scratch the surface of the glass assembly.
Latches
(both bottom
and top)
Glass
Assembly
Figure 14.8 Fixed Glass Assembly
Replacing Glass Assembly
•
Replace the glass assembly on the lower access
latches.
•
Rotate the upper portion of the glass assembly into
place.
•
Engage the top access latches.
•
Engage the lower access latches.
•
Reinstall upper latch cover (see Figure 14.12).
•
Reinstall lower latch cover (see Figure 14.14).
•
Reinstall mesh fi rescreen (see Figure 14.15).
31