Fixed Glass Assembly; Install Trim And/Or Surround; Air Shutter Setting; Refractory Color Review - Heatilator CD4236IR-C Owner's Manual

H. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
• Pull the four glass assembly latches out of the groove on
the glass frame. Remove glass door from the appliance
(see Figure 14.5).
Replacing Fixed Glass Assembly
• Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove on
the glass frame.
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Figure 14.5 Fixed Glass Assembly
I. Install Trim and/or Surround
• Install optional trim kits and/or surrounds using the
instructions included with the accessory.
• Use non-combustible materials to cover the gap between
the sheet rock and the appliance (when applicable to the
model).
56 Heatilator • CD4236IR-C, CD4842IR-C • 2207-900 Rev. L • 3/14
J. Air Shutter Setting
Air shutter settings should be adjusted by a qualifi ed ser-
vice technician at the time of installation. The air shutter is
set at the factory for minimum vertical vent run. Adjust air
shutter for longer vertical runs. See Figure 14.6.
• Loosen the wing nut.
• Move the air handle to the right to open the air shutter.
• Move the air handle to the left to close the air shutter.
• Tighten the wing nut.
NOTICE: If sooting occurs, provide more air by opening
the air shutter.
Figure 14.6 Air Shutter
Air Shutter Settings
CD4236IR-C
CD4842IR-C
K. Refractory Color Review
Based on the installation of the appliance, the lighting may
cause the back refractory panel to appear lighter than the
side panels. In these rare cases, the recommended solu-
tion is to use the tested and approved aerosol touchup
paint (TUP-GBK-12) to fog the back panels to match the
side panels.
AIR SHUTTER WING NUT
NG LP
1/8 in. 5/8 in.
5/16 in. Fully Open