Install The Log Assembly - Heatilator NDI30-C Owner's Manual

G. Install the Log Assembly
Log Set Assembly: LOGS-NDI30
Models: NDI30, NDI30-SP, NDI30-C
CAUTION: Logs are fragile, handle with care.
PILOT ASSEMBLY PILOT ASSEMBLY
LOG SHELF LOG SHELF
GRATE BAR GRATE BAR
Figure 1.
Log #1 (SRV2226-701) Position Log #1 as shown in Figure 2. Note additional placement instructions in Figure 1. Set the
rear log (Log #1) on the log shelf. Position the log against the back of the fi rebox. Center the log notch over the pilot assembly.
FLAT SPOT FOR FLAT SPOT FOR
LOG #5 LOG #5
MATE LOG MATE LOG
TOUCHES TOUCHES
PIN WITH PIN WITH
GRATE TINE GRATE TINE
LOG SLOT LOG SLOT
Figure 3. Place Log #2
Log #2 (SRV2226-702): Position Log #2 as shown in Figure 3. Refer to Figure 1 and Figure 4 for additional details. Mate
the slot located on the bottom of Log #2 with the log pin located on the right side of the burner. Move the right end of Log
#2 forward until it comes into contact with the grate tine.
Heatilator • NDI30-C, NDI30-SP, NDI35-C, NDI35-SP, NDI30-SPFK, NDI35-SPFK • 2226-901 Rev. K • 11/12
LOG PINS LOG PINS
GRATE GRATE
TINES TINES
FLAT SPOT FLAT SPOT
FOR LOG #6 FOR LOG #6
2 2
LOG LOG
SRV2226-701 SRV2226-701
SRV2226-704 SRV2226-704
SRV2226-703 SRV2226-703
FLAT SPOT FOR FLAT SPOT FOR
LOG #5 LOG #5
FLAT SPOT FLAT SPOT
FOR LOG #4 FOR LOG #4
Figure 2. Install Log #1
Figure 4. Log #2
SRV2226-705 SRV2226-705
SRV2226-706 SRV2226-706
SRV2226-702 SRV2226-702
FLAT SPOT FOR FLAT SPOT FOR
LOG #6 LOG #6
1 1
LOG LOG
NOTCH NOTCH
SLOT SLOT
33