Install The Log Assembly - Heatilator GDST4336IFT Installation Manual

E. Install the Log Assembly
LOGS-2129
CAUTION: DO NOT reposition logs that have been
factory installed! Follow these instructions to position
the logs that were packaged separately.
Figure 1. Log Assembly Location
CAUTION!
Logs are fragile! Carefully remove the logs and cardboard tray from the inside of the fi replace. See Figure
Remove the microfoam and inspect the logs for damage. Inspect the four factory installed logs for damage. Locate the
pilot in order to verify your position in relation to the appliance. See Figure 2.
Figure 3. Placement of Log #1
STEP 1. Log #1 (SRV2129-704):
on Log A highlighted in Figure 3. The Y-shaped end of Log #1 will rest on the smooth area of Log B as shown in Figure 4.
60
PILOT PILOT
1 1
A A
Place Log #1 on Log A. The end and bottom of Log #1 fi t into the indentation
Heatilator • GDST4336IFT, GDFL4136IFT Installation Manual • 2480-980 Rev. B • 3/17
LOG PLACEMENT INSTRUCTIONS
3 3
Log Set Components
PILOT PILOT
A A
B B
Figure 2. Factory Installed Logs and Pilot Position
C C
Figure 4. Placement of Log #1
2 2
1 1
D D
C C
PILOT PILOT
1 1
B B
HUMP HUMP
1 1
A A