Setting Levels Diagram - Omron E5CN User Manual

Setting Levels Diagram

This diagram shows all of the setting levels. To move to the advanced function setting level and calibration
level, you must enter passwords. Some parameters are not displayed depending on the protect level setting
and the conditions of use.
Control stops when you move from the operation level to the initial setting level.
Started in manual mode.
Press the O Key
for at least 1 s.
C
a-m
Press the O Key for
at least 1 s; display
(See
will flash.
note
Press the Ol Key for
Manual
at least 3 s while a-m
3.)
mode
is displayed.
Manual Control
Level
Note (1) Moves to operation level by software reset.
(2) It is not possible to move to other levels from the calibration level by operating the keys on the front
panel. It can be done only by first turning OFF the power.
(3) From the manual control level, key operations can be used to move to the operation level only.
Power ON
Started in automatic mode.
Operation Level
Press the
O Key less than 1 s.
Press the
O Key
(See
for at
note 1.)
least 1 s.
Initial Setting Level
Press the O Key
for at least 1 s.
Advanced Function
Setting Level
Calibration Level
Adjustment Level
Press the O
+ M Keys for
at least 1 s.
Press the O Key for at
C
25
least 1 s; display will flash.
Press the O Key for at
100
least 3 s.
Control stops.
Communi-
cations Set-
ting Level
Press the
O Key for less than 1 s.
Input password.
Set value 169
Input password.
Set value 1201
(See
note 2.)
Appendix A
Press the O +
M keys; display
will flash.
C
25
100
Press the O +
M Keys for at
least 3 s. (See
note.)
Protect level
Note: The time taken to move
to the protect level can
be adjusted by chang-
ing the "Move to pro-
tect level time" setting.
Control in progress
Control stopped
Not displayed for some models
Level change
221