Omron E5CN User Manual page 147

Operation Level
See
See
al-2
Alarm Value 2
Function
Setting
See
See
al-3
Alarm Value 3
Function
Setting
■ Related Parameters
Input type: Page 146, Scaling upper limit, Scaling lower limit, Decimal point
(initial setting level): Page 148 (initial setting level)
Alarm 1 type (initial setting level): Page 152
Standby sequence reset: Page 161, Alarm 1 open in alarm: Page 162, Alarm
1 hysteresis: Page 163, Alarm 1 latch: Page 167 (advanced function setting
level)
This parameter is set to one of the input values "X" in the alarm type list.
• This parameter sets the alarm value for alarm output 2.
• During temperature input, the decimal point position depends on the cur-
rently selected sensor, and during analog input it depends on the "decimal
point" parameter setting.
Setting range
1999 to 9999 EU
■ Related Parameters
Input type: Page 146, Scaling upper limit, Scaling lower limit, Decimal point
(initial setting level): Page 148 (initial setting level)
Alarm 2 type (initial setting level): Page 154
Standby sequence reset: Page 161, Alarm 2 open in alarm: Page 162, Alarm
2 hysteresis: Page 163, Alarm 2 latch: Page 167 (advanced function setting
level)
This parameter is set to one of the input values "X" in the alarm type list.
• This parameter sets the alarm value for alarm output 3.
• During temperature input, the decimal point position depends on the cur-
rently selected sensor, and during analog input it depends on the "decimal
point" parameter setting.
Setting range
1999 to 9999 EU
Alarm 2 must be assigned.
The alarm 2 type must be set to
other than an upper and lower limit
alarm.
Unit Default
0
Alarm 3 must be assigned.
The alarm 3 type must be set to
other than an upper and lower limit
alarm.
Unit Default
0
Section 5-3
125