Making Coffee Using Pre-Ground Coffee; Making Drinks With Milk; Filling And Attaching The Milk Container; Making Cappuccino Or Macchiato - DeLonghi ECAM23.450 Instructions For Use Manual

the machine. Their meaning is explained in
the section "Displayed messages" (page
22).
Please note!
If "Energy Saving" mode is active, you may have
to wait a few seconds before the first coffee is
delivered.

Making coffee using pre-ground coffee

Important!
• Never add pre-ground coffee when the ma-
chine is off or it could
spread through the inside
of the machine and dirty
it. This could damage the
appliance.
• Never use more than 1
level measure or it could dirty the inside of
the coffee maker or block the funnel.
• Use pre-ground coffee for espresso coffee
machines.
Please note!
If you use pre-ground coffee, you can only
make one cup of coffee at a time.
1. Press the
ground" is displayed.
2. Make sure the funnel is not blocked, then
add one level measure of pre-ground coffee
(fig. 14).
3. Place a cup under the coffee spouts.
4. Press the 1 cup coffee button
5. Preparation begins. The amount of coffee se-
lected is displayed together with a progress
bar which gradually fills as preparation pro-
gresses.
button (fig. 7) until "Pre-
(fig. 9).

MAkING DRINkS WITH MIlk

Please note!
To avoid milk with poor froth or large bubbles,
always clean the milk lid and hot water nozzle
as described in the section "Cleaning the milk
container" on pages 15 and 18.

Filling and attaching the milk container

1. Remove the lid (fig. 23);
2. Fill the milk container with a sufficient quan-
tity of milk, not exceeding the MAX level
marked on the container (fig. 16). Each mark
on the side of the container corresponds to
100 ml of milk.
Please note!
• For a denser more even froth, you should
use skimmed or partially skimmed milk at
refrigerator temperature (about 5°C).
• To avoid producing milk with poor froth
or large bubbles, always clean the milk lid
and hot water nozzle as described in the
sections "Cleaning the milk frothe with
the CLEAN button" on page 15 and "Cle-
aning the milk container" on page 17.
3. Make sure the milk intake tube is correctly
inserted in the bottom of the milk container
lid (fig. 17).
4. Place the lid back on the milk container.
5. Remove the hot water spout from the nozzle
(fig. 18).
6. Attach the container to the nozzle and push
as far as it will go (fig. 19). The machine
emits a beep.
7. Place a sufficiently large cup under the coffee
and frothed milk spouts. Adjust the length of
the milk spout. To move it nearer the cup,
simply pull it downwards (fig. 20).
8. Follow the instructions below for each fun-
ction.

Making cappuccino or macchiato

1. After attaching the milk container, turn the
froth adjustment knob on the milk container
lid between position 2
21).
2. Press the CAPPUCCINO button on the control
panel. "CAPPUCCINO" is displayed, together
14
and 3 (fig.