Table of Contents
Advertisement
in the cup, just press (within 3 seconds) one of the coffee
buttons�
Please note :
For hotter coffee, see the section "Tips for a hotter coffee"�
Important!
•
If the coffee is delivered a drop at a time, too thin and
not creamy enough or too cold, read the tips in the
"Troubleshooting" section on page 18�
•
Lights may be displayed on the control panel during use.
Their meaning is given in the section "Explanation of the
lights" on page 17�
making coffee using pre-ground coffee
Important!
•
Never place coffee beans in the pre-ground coffee funnel
as this could damage the appliance�
• Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it� This could damage the appliance�
• Never use more than 1 level
measure or it could dirty the
inside of the coffee maker or
block the funnel�
Please note :
When using pre-ground coffee, you can only make one cup of
coffee at a time�
1� Make sure the appliance is on�
2� Turn the coffee taste selection dial anticlockwise as far as
it will go to the
position (fig� 18)�
3� Make sure the funnel is not blocked, then add one level
measure of pre-ground coffee (fig� 19)�
4� Place a cup under the coffee spouts�
5� Press the 1 cup coffee button (
6� Preparation begins�
mAkING CAPUCCINO
Danger of burns!
During preparation, steam is given off� Take care to avoid
scalds�
1� When making cappuccino, prepare the coffee in a large
cup;
2� Fill a container (preferably with a handle to avoid burns)
with about 100 grams of milk for each cappuccino to be
made� In choosing the size of the container, bear in mind
or
)�
13
that the milk doubles or triples in volume�
Please note :
For a richer denser froth, use skimmed or partially
skimmed milk at refrigerator temperature (about 5°C)�
To avoid milk with poor froth or large bubbles, always
clean the cappuccino maker as described in the section
"Cleaning the cappuccino maker after use"�
3� Press the
button� The
4� Immerse the cappuccino maker in the milk container (fig�
20)�
5� After a few seconds, when the
the steam dial to the I position (fig� 5)� Steam is delivered
from the cappuccino maker, giving the milk a creamy
frothy appearance and making it more voluminous�
6� To obtain a creamier froth, rotate the container with slow
upward movements� You should not deliver steam for
more than 3 minutes at a time�
7� When you have obtained the required froth, stop steam
delivery by turning the steam dial back to the 0 position�
Danger of burns!
Stop steam delivery before removing the container with
the frothed milk to avoid burns caused by splashes of
boiling milk�
8� Add the milk froth to the coffee prepared previously�
The cappuccino is ready� Sweeten to taste and, if desired,
sprinkle the froth with a little cocoa powder�
Cleaning the cappuccino maker after use
Clean the cappuccino maker after use to avoid the build-up of
milk residues or blockages�
1� Place a container under the cappuccino maker and deliver
a little water for a few seconds by rotating the steam dial
to the I position (fig� 5)�
Then turn the steam dial to the 0 position to stop the flow
of hot water�
2� Wait a few minutes for the cappuccino maker to cool
down� Grip the handle of the cappuccino maker tube
firmly in one hand and with the other rotate the
cappuccino maker anticlockwise (fig� 16), then remove by
pulling downwards�
3� Also remove the steam nozzle by pulling it downwards
(fig� 17)�
4� Make sure the two holes shown by the arrow in fig� 18 are
not blocked� If necessary, clean with a pin�
5� Wash all parts of the cappuccino maker thoroughly with a
sponge and warm water�
6� Replace the nozzle and put the cappuccino maker back
on the nozzle, pushing it and turning it upwards until it
is attached�
light flashes�
light flashes, turn
Advertisement
Table of Contents
Troubleshooting
