CONTENTS 10. MAKING CAPPUCCINO AND HOT MILK (NOT FROTHED) ..........13 1. FUNDAMENTAL SAFETY WARNINGS .....7 10.1 Making hot milk (not frothed).....14 10.2 Cleaning the cappuccino maker after use ..14 2. SAFETY WARNINGS ........8 2.1 Symbols used in these instructions ....8 11.
1. FUNDAMENTAL SAFETY WARNINGS • The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
2. SAFETY WARNINGS Any other use is considered improper and thus dangerous. The manufacturer is not liable for damage deriving from improper 2.1 Symbols used in these instructions use of the appliance. Important warnings are identified by these symbols. It is vital to follow these warnings.
fee in the mill. The machine is, however, guaranteed to be During rinsing, a little hot water comes out of the coffee spouts new. (A12) and is collected in the drip tray (A17) underneath. Avoid • You should customise water hardness as soon as possible contact with splashes of water.
3. Press the button (B9 - fig. 2). This sets the time. Press the (B4) button to exit the 4. Turn the selection dial until the required temperature menu. (high, medium, low) is displayed; 5. Press the button to confirm; 8.3 Auto-off Auto-off can be changed so that the appliance goes off after 15 6.
8.11 Enable/disable the beep To change the taste, press the button (B6 - fig. 7) This enables or disables the beep emitted by the machine each repeatedly until the required taste is displayed. time the button is pressed or an accessory is inserted/removed. The beep is active by default.
If the coffee is delivered too slowly Please note: or not at all, turn one click clockwise For hotter coffee, see the section “9.5 Tips for a hotter coffee”. towards “7”. For fuller bodied creamier coffee, turn Important! one click anticlockwise towards “1” (do not turn more than one click at •...
In choosing the size of the container, bear in mind that the 3. Move the selection ring (A18) upwards (fig. 19). milk doubles or triples in volume; 4. Remove the nozzle downwards (fig. 20). 5. Make sure the two holes shown by the arrow in fig. 21 are not blocked.
12.2 Cleaning the machine’s internal circuit 12.5 Cleaning the inside of the coffee machine If the appliance is not used for more than 3-4 days, before Danger of electric shock! using it again, we strongly recommend switching it on and Before cleaning the internal parts, the machine must be turned performing: off (see “7 Turning off”) and unplugged from the mains power...
Clean the infuser without using washing up liquid as it could 8. Place an empty container with a minimum capacity of 1.8 be damaged. litres under the cappuccino maker (A19) and coffee spouts (A12) (fig. 33); 5. Soak the infuser in water for about 5 minutes, then rinse Important! Danger of burns under the tap;...
15.1 Installing the filter Please note! 1. Remove the filter (C4) from the packaging; • If the descaling cycle is not completed correctly (e.g. no Turn the date indicator electricity) we recommend repeating the cycle; disk until the next two •...
16. TECHNICAL DATA 14. Press the button to confirm the selection. The appli- Voltage: 220-240 V~ 50/60 Hz max. 10 A ance begins hot water delivery and the message “Please Power: 1450 W wait” is displayed; Pressure: 1,5 MPa (15 bar) 15.
18. DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION EMPTY GROUNDS CONTAINER The grounds container (A13) is full. Empty the grounds container and drip tray (A17), clean and replace. Important: when removing the drip tray, the grounds contai- ner must be emptied, even if it contains few grounds.
FILL BEANS CONTAINER The coffee beans have run out. Fill the beans container (A7). The pre-ground coffee funnel (A6) Empty the funnel with the help of a knife, as is clogged. described in the section "12.8 Cleaning the pre-ground coffee funnel". INSERT INFUSER ASSEMBLY The infuser has not been replaced Insert the infuser as described in the section...
The frothed milk has large The milk is not cold enough or is not You should ideally use skimmed or semi-skim- bubbles. semi-skimmed. med milk at refrigerator temperature (about 5°C). If the result is not as you wished, try changing brand of milk. The milk is not frothed.