Troubleshooting - DeLonghi ECAM23.450 Instructions For Use Manual

DISPlAYED MESSAGE
Press CLEAN button
INSERT WATER SPOUT
INSERT MILK
CONTAINER!

TROUBlESHOOTING

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBlEM
The coffee is not hot
The coffee is thin or
not creamy enough.
The coffee is delivered
too slowly or a drop at
a time.
Coffee does not come
out of one of the
spouts.
The milk does not
come out of the milk
spout.
POSSIBlE CAUSE
• Milk has been delivered recently and the
tubes inside the milk container must be
cleaned.
• The hot water spout is not inserted or is
inserted incorrectly.
• The milk container is not inserted
correctly.
POSSIBlE CAUSE
• The cups were not preheated.
• The infuser has cooled down because
2/3 minutes have elapsed since the last
coffee was made.
• Low coffee temperature is set.
• The coffee is ground too coarsely.
• The coffee is unsuitable.
• The coffee is ground too finely.
• The spouts are blocked.
• The milk container lid is dirty.
REMEDY
• Press the CLEAN button and keep it
pressed until the progress bar which
appears on the display together with the
message "Cleaning..." is complete.
• Insert water spout as far as it will go.
• Insert the milk container as far as it will
go.
REMEDY
• Warm the cups by rinsing them with hot
water (N.B. you can use the hot water
function).
• before making the coffee, warm the
infuser by pressing the
• In the menu, set a high coffee
temperature.
• Turn the grinding adjustment knob one
click anticlockwise towards "1" while
the coffee mill is in operation (fig. 10).
Continue one click at a time until coffee
delivery is satisfactory. The effect is only
visible after delivering 2 coffees (see the
section: "Adjusting the coffee mill" on
page 13).
• Use pre-ground coffee for espresso
coffee makers
• Turn the grinding adjustment knob
one click clockwise towards "7" while
the coffee mill is in operation (fig. 10).
Continue one click at a time until coffee
delivery is satisfactory. The effect is only
visible after delivering two coffees. (see
the section "Adjusting the coffee mill" on
page 13).
• Clean the spouts with a toothpick (fig.
26B).
• Clean the milk container lid as described
in the section "Cleaning the milk
container".
23
button .