Configuration - Trane Thermostats Installation And Operation Manual

Configuration

NOTICE
Adverse Control System Behavior!
Improper configuration could cause unwanted, possibly adverse control system behavior. Be
sure to configure the thermostat according to your system type.
To change the installation configuration:
1. Apply electrical power to the thermostat.
2. See the appropriate table for your thermostat type to determine the configuration options you
3. Write down your selections or other notes on the table.
4. Enter installer configuration mode:
Live Electrical Components!
The circuit board is energized. Have a qualified licensed electrician or other individual who has
been properly trained in handling live electrical components perform this step. Failure to follow
all electrical safety precautions when exposed to live electrical components could result in death
or serious injury.
Figure 34. Pressing the Configuration Button
Programmable 3H/
Figure 35. Configuration Mode
26
need:
• Table 6, p. 27 for 3-Heat/2-Cool programmable thermostats
• Table 7, p. 31 for 3-Heat/2-Cool non-programmable thermostats
• Table 8, p. 32 for 1-Heat/1-Cool, non-programmable thermostats
WARNING
a. Remove the thermostat cover.
b. Press and hold the configuration button for at least 3 sec.
2C configuration
button
The configuration wrench icon
Value
Option
Number
Non-Programmable
Thermostat
Programmable
Thermostat
Note: Configuration mode automatically ends if no buttons are pressed for 10 min.
Thermostat Non-Prog XH/XC
X########-## Rev X
BAYSTAT15#X
####XXX
appears, along with the option number and value:
Non-programmable
thermostats
configuration button
BAS-SVX36C-EN