Trane BAYSTAT150A Setup Instructions

Setup Instructions
Trane Programmable Thermostat
Model Number: X13511537-01/BAYSTAT150A/THT02774
More information:
https://www.trane.com/stat
SAFETY WARNING
Only qualified personnel should install and service the equipment. The installation,
starting up, and servicing of heating, ventilating, and air-conditioning equipment
can be hazardous and requires specific knowledge and training. Improperly
installed, adjusted or altered equipment by an unqualified person could result in
death or serious injury. When working on the equipment, observe all precautions in
the literature and on the tags, stickers, and labels that are attached to the
equipment.
June 2020 BAS-SVN197C-EN
2
Fan Mode
The fan mode is displayed only on systems configured with the fan
enabled.
For systems configured with a fan, the fan setting is shown on the
display. In addition, the setting also appears on the display when
pressing , , from the Home screen.
The fan mode setting can be overridden by pressing
fan mode flashes. Press and hold
to Save and Exit. Refer to the section,
Auto Mode:
Auto Flashes
Important: When this thermostat is configured in
programmable mode (0140=1), then changing the Fan
Mode from the Home screen puts the thermostat into
Timed Override (TOV) and is only temporary. The fan
goes back to the schedule setting after the TOV timer
expires.
X39641168-01
© 2020 Trane
or
for 2 seconds or wait 10 seconds
"Timed Override (TOV)".
On Mode:
Arrows Flash
1
Time Setup
To change the current time:
1. From the Home screen, press
2. Press ,
Hours
1. Press to increase or
AM
Changing Hours
1. Press and hold
System Mode Setup
To set the system mode:
1. From the operating screen, press
2. Press or
Emergency
Heat
Note: Not all system choices may be available depending on the
system configuration 0130.
3. Press and hold
3
Timed Override (TOV)
A timed override can be used to temporarily change the heating
setpoint, cooling setpoint, fan mode, and/or occupancy setting from the
programmed schedule. The override can be set for up to 99 days and up
to 23 hours.
To enter a timed override:
1. From the operating screen, press
when the
enters timed override mode with the hourglass
flashing.
2. Press or press
the selections. Some of the selections may not be available
depending on the system type.
Cooling
Setpoint
3. Press or
selections. Repeat steps 2 and 3 for the desired settings.
Note: To reach the DAYS setting, the user must press
hours setting.
4. Press and hold
Note: The thermostat will return to the scheduled operation when:
• the override time expires, or
• pressing and holding
Important: When in timed override mode, if the system
selection is changed (EmHeat, Heat, Cool, Auto, OFF), this
change will take the thermostat out of TOV mode.
Important: Whenever the thermostat is in TOV mode, a
solid hour glass ( ) indicator displays at the bottom of the
screen.
, , ,
, or to scroll between hours and minutes.
AM
PM
Minutes
to decrease the hour or minute.
PM
Changing Minutes
for 2 seconds or wait 10 seconds to Save and Exit.
, . The current mode flashes.
to select a mode.
OFF
Heat Cool Auto H/C
for 2 seconds or wait 10 seconds to Save and Exit.
or
or to move from either left or right through
DAYS HOURS
(Days)*
Fan Occupancy Hours
Setting Setting
to change the value of the currently active (flashing)
for 2 seconds or wait 10 seconds to Save and Exit.
an for 2 seconds.
, , .
PM PM
Off
2 times.The thermostat
and setpoint
Heating
Setpoint
from the