Day-To-Day Operation; Showing The Setpoint Or Temperature On Display - Trane Thermostats Installation And Operation Manual

Day-to-Day Operation

After a programmable thermostat is configured and the schedule is programmed, the thermostat
automatically changes the setpoints and fan settings according to the schedule.However, there are
some operator tasks that you may need or want to perform:
•
•
•
•
Note: It is possible for a programmable thermostat to be configured to be a non-programmable

Showing the Setpoint or Temperature on Display

Depending upon the value of configuration option #210, the large numeric display could show any
of the following:
Figure 37. Display Options
Value of configuration
option #210
0
1 or 2
3
To switch between the current temperature, "o dr" temperature, and the setpoint temperature,
press and hold the
BAS-SVX36C-EN
Show setpoint or current temperature.You can temporarily or permanently switch the main
display from current temperature to temperature setpoint. See
Temperature on Display, " p.
Set the system mode, which includes turning the system on or off, and switching between
heating, cooling, and automatic heating and cooling. See
Override the schedule. If an unexpected, one-time temperature setpoint or fan mode change is
needed you can temporarily override the schedule. See
Lock or unlock.You can lock the thermostat buttons to prevent changes to the thermostat
settings. See "Locking or Unlocking Modes, " p.
thermostat. If installation configuration option #140 is set to 0, schedule programming
capabilities will be absent.
Mo
. .
AM
Current temperature
Numeric display options
(press
The current local temperature, or the current or most recent temperature setpoint
The current local or remote indoor temperature or the current or most recent temperature
setpoint
The current indoor temperature, the current or most recent temperature setpoint, or the
current remote outdoor temperature, which only appears for 8 sec before reverting to
current indoor temperature or setpoint
and
39.
40.
Arrow indicates
setpoint
Current (or most
recent) setpoint
and for 3 sec to change)
buttons for 3 sec.The display will toggle as shown in
"Showing the Setpoint or
"Changing the System Mode, " p.
"Timed Override (TOV) Mode, " p.
"o dr" indicates outdoor
temperature (after 8 sec,
returns to previous mode)
Current outdoor
temperature
Operation
34.
40.
Figure 37.
39