Panasonic LUMIX DMC-FZ18 Operating Instructions Manual page 159

[MEMORY CARD PARAMETER ERROR]
Use a card compatible with this unit.
• You can only use an SDHC Memory Card if
using cards with 4 GB or more capacity.
[MEMORY CARD ERROR
PLEASE CHECK THE CARD]
• An error has occurred accessing the card.
Insert the card again.
[READ ERROR
PLEASE CHECK THE CARD]
An error has occurred reading the data.
Insert the card again. Make sure the card is
inserted properly and then play back again.
[WRITE ERROR
PLEASE CHECK THE CARD]
An error has occurred writing the data.
Turn the camera off and remove the card.
Insert the card again and turn the camera on.
Make sure the camera is turned off before
removing or inserting the card to avoid
damage.
[MOTION RECORDING WAS CANCELLED
DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
• When you set the picture quality to
[30fpsVGA] or [30fps16:9], we recommend
using a High Speed SD Memory Card with
"10MB/s" or greater displayed on the
package.
• Depending on the type of SD Memory Card
or SDHC Memory Card, motion picture
recording may stop in the middle.
[A FOLDER CANNOT BE CREATED]
A folder cannot be created because there are
no remaining folder numbers that can be
used. (P143)
Format the card after saving necessary data
on a PC etc. (P140)
If you execute [NO.RESET] in the [SETUP]
menu after formatting, the folder number is
reset to 100. (P27)
Others
[PICTURE IS DISPLAYED FOR 4:3 TV]/
(P4, 18) [PICTURE IS DISPLAYED FOR 16:9 TV]
• The AV cable is connected to the camera.
Press [MENU/SET] if you want to delete this
message at once.
• Select [TV ASPECT] in the [SETUP] menu if
you want to change the TV aspect.
• This message also appears when the USB
connection cable is connected to the camera
only.
In this case, connect the other end of the
USB connection cable to a PC or a printer.
(P142, 145)
[PLEASE RE-CONNECT THE PRINTER.]
This message will be displayed if you change
the mode dial to print mode [
unit is connected to a PC. If connecting the
printer again, change the mode to a mode
other than [
is being transferred.
([ACCESS] appears on the LCD monitor while
data is being transferred.)
[USB MODE CHANGED. PLEASE REMOVE
THE USB CABLE.]
This message will be displayed if you change
the mode dial to a mode other than print
mode [
connected.
Set the mode dial to [
disconnect the USB connection cable. If
printing, stop the printing and then disconnect
the USB connection cable.
[PRINTER BUSY]/[PLEASE CHECK THE
PRINTER]
The printer cannot print. Check the printer.
- 159 -
] and then check that no data
] while this unit and the printer are
] again and then
(P28)
], while this