Message Display - Panasonic LUMIX DMC-FZ18 Operating Instructions Manual

Message Display

Confirmation messages or error messages
will be displayed on the screen in some
cases.
The major messages are described below as
examples.
[THIS MEMORY CARD IS LOCKED]
The Write-Protect switch on the SD Memory
Card and the SDHC Memory Card are moved
to [LOCK]. Move the switch back to unlock it.
(P18, 135, 141)
[NO VALID PICTURE TO PLAY]
Record a picture or insert a card with a
recorded picture and then play it.
[THIS PICTURE IS PROTECTED]
Delete or overwrite the picture after cancelling
the protect setting. (P134)
[THIS PICTURE CANNOT BE DELETED]/
[SOME PICTURES CANNOT BE DELETED]
Pictures not based on the DCF standard
cannot be deleted. If you want to delete some
pictures, format the card after saving
necessary data on a PC etc.
[NO ADDITIONAL DELETE SELECTIONS
CAN BE MADE]
You have exceeded the number of pictures
that can be set at one time with
[MULTI DELETE] (P43)
STAMP] (P130)/[TITLE EDIT] (P128).
Either delete the picture or stamp the entered
text or dates onto the picture, then retry the
operation.
More than 999 favourites have been set.
[CANNOT BE SET ON THIS PICTURE]
[TITLE EDIT], [TEXT STAMP] or DPOF
cannot be set for pictures not based on the
DCF standard.
(P140)
or [MULTI] in [TEXT
- 158 -
Others
[NOT ENOUGH SPACE ON BUILT-IN
MEMORY]/[NOT ENOUGH MEMORY ON
THE CARD]
There is no space left on the built-in memory
or the card.
• When you copy pictures from the built-in
memory to the card (batch copy), the
pictures are copied until the capacity of the
card becomes full.
[SOME PICTURES CANNOT BE COPIED]/
[COPY COULD NOT BE COMPLETED]
The following pictures cannot be copied.
• When a picture with the same name as the
picture to be copied exists in the copy
destination.
(Only when copying from a card to the
built-in memory.)
• Files not based on the DCF standard.
Moreover, pictures recorded or edited by
other equipment may not be copied.
[BUILT-IN MEMORY ERROR
FORMAT BUILT-IN MEMORY?]
This message will be displayed when you
formatted the built-in memory on a PC.
Format the built-in memory on the camera
again. (P140) The data on the built-in
memory will be deleted.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
The card format cannot be recognised by the
camera. Format the card again with the
camera after saving necessary data on a PC
etc. (P140)
[PLEASE TURN CAMERA OFF AND THEN
ON AGAIN]
This message appears when the camera did
not operate properly because force was
applied to the lens by a hand or other object,
or the hood adaptor is not securely attached.
Turn the camera off and on. If the message is
still displayed, contact the dealer or your
nearest Service Centre.