Connections; Connection With Scart Cable - Panasonic Diga DMR-EX80S Operating Instructions Manual

Connections

Before connection, turn off
all equipment and read
the appropriate operating
instructions.
If your TV set supports RGB, in the Setup menu,
adjust the AV1 Output to [RGB 1] or [RGB 2].
Rear panel television
LNB
IN
Y
COMPONENT VIDEO OUT
1
Antenna cable
(not provided)
For TV sets supporting the Q Link
Direct TV Recording
TV/DVD automatic switch on: Both units are automatically switched on with PLAY, DIRECT NAVIGATOR, GUIDE
or PROG/CHECK.
If your TV set is in standby mode, it is switched on automatically with FUNCTION MENU, PLAY or on inserting a disc
(not with DVD-RAM, DVD-R, DVD-RW (DVD-Video format) and +R).
DVD automatic switch off: If you switch your TV set off, the DVD Recorder will also be switched off if it is in the STOP
mode.
You can also program Timer Recordings using your TV set.
10

Connection with Scart cable

Select one of the described connection types A-E.
For this optimum connection type, you will need a fully wired 21-pin Scart cable (not
provided).
1 Connect the satellite dish to LNB IN of the DVD Recorder.
Connect the AV1(TV) terminal (21-pin Scart socket) of the DVD Recorder to the
2
Scart input of the television.
3 Connect the DVD Recorder and the television to the power supply system.
After completing the above connections, the DVD Recorder proceeds with the
Automatic Setup.
Conditional Access module: The size of the Scart terminal prevents the Conditional
Access module from being inserted in the slot afterwards. Insert the module before
completing the above connections.
AV IN
2
Slot for Conditional
Access module
LNB
OUT
COMMON
AV1(TV) INTERFACE
B
AV2 (EXT)
18
65
21-pin Scart cable (fully wired)
Necessary for TV with Q Link
AV OUT
OPTICAL
DIGITAL AUDIO OUT
VIDEO S VIDEO (PCM/BITST EAM)
AC mains supply
(AC 220 V - 240 V, 50 Hz)
(Registered trademark of Panasonic)
46
20
3
AC mains lead
Rear panel DVD Recorder
AC IN
3
AC mains lead
A A