Table of Contents
Advertisement
7. Programmable Features
7.1 Base unit programming
MMENUN
MSETN
7.1.1 Basic features
Feature
Setting the date and time
MBNM0NM1N
Setting your logo
MBNM0NM2N
Setting your fax number
MBNM0NM3N
Printing a sending report
MBNM0NM4N
Changing the ring count in
FAX ONLY mode
MBNM0NM6N
Changing the ring count in
*1
TAM/FAX mode
MBNM0NM6N
Changing the maximum
recording time for incoming
*1
messages
MBNM1NM0N
Setting the remote operation
*1
ID
MBNM1NM1N
42
Selection
*1
Enter the date and time using the dial keypad. See page 22 for details.
Enter your logo using the dial keypad. See page 22 for details.
Enter your fax number using the dial keypad. See page 23 for details.
M0N "OFF": Sending reports will not be printed.
M1N "ON": A sending report will be printed after every fax transmission.
M2N "ERROR" (default): A sending report will be printed only when a fax
transmission fails.
M1N "1", M2N "2" (default), M3N "3", M4N "4", M5N "5", M6N "6", M7N "7", M8N
"8", M9N "9"
Note:
R Set feature #77 to "FAX ONLY" (page 46) beforehand.
M0N "AUTO", M2N "2" (default), M3N "3", M4N "4", M5N "5", M6N "6", M7N "7"
See page 35 for details.
Note:
R Set feature #77 to "TAM/FAX" (page 46) beforehand.
R You can also program this feature with the cordless handset (page 40).
M1N "1 MINUTE"
M2N "GREETING ONLY": The unit plays the greeting message but does not
record any incoming messages.
M3N "3 MINUTES" (default)
Note:
R You can also program this feature with the cordless handset (page 40).
1. MMENUN A MBNM1NM1N
2. To activate the remote operation feature, enter a 3-digit remote operation
ID.
R To deactivate the remote operation feature, press MGN.
3. MSETN A MMENUN
Note:
R You can also program this feature with the cordless handset (page 40).
1. MMENUN
2. Press MBN and the 2-digit code (page 42 to
page 46).
3. Press the desired command to display the desired
setting.
R This step may be slightly different depending on
the feature.
4. MSETN
5. To exit programming, press MMENUN.
Advertisement
Table of Contents
