Feature
Setting the memory
reception alert
Setting friendly
reception
Setting the auto
disconnection
Changing the greeting
message time for
TAM/FAX
Setting the print
contrast
Setting the scan
contrast
Copying phonebook
data from the base unit
to the cordless handset
Screening the incoming
*1
call
Code
Selection
To alert you with a beeping sound when a received fax document
{#}{4}{4}
is stored into memory due to some existing problem.
{0} "OFF": Deactivates this feature.
{1} "ON" (default): You will hear a beeping sound.
Note:
L The slow beeps will continue until you clear the printing
problem and make sure the unit is supplied with enough paper
to print the stored document.
To receive a fax automatically when you answer a call and hear a
{#}{4}{6}
fax calling tone (slow beep).
{0} "OFF": You have to press {FAX/START} for fax reception.
{1} "ON" (default): You do not have to press {FAX/START} for fax
reception.
To answer a call with an extension telephone in TEL/FAX mode
{#}{4}{9}
(page 30) or TAM/FAX mode (page 31), activate this feature and
program the code.
{0} "OFF"
{1} "ON" (default)
1. {MENU} i {#}{4}{9}
2. Press {1} to select "ON". i {SET}
3. Enter your code from 2 to 4 digits, using 0-9 and {*}.
4. {SET} i {MENU}
{1} "16s" (default): Maximum greeting message time is 16
{#}{5}{4}
seconds.
{2} "60s": Maximum greeting message time is 60 seconds.
See page 35 for details.
To adjust the darkness of received or copied documents.
{#}{5}{7}
{1} "NORMAL" (default): Normal contrast.
{2} "DARKER": Darker contrast.
To send or copy a document with faint or dark writing, set this
{#}{5}{8}
feature before transmission or copying.
{1} "NORMAL" (default): Used for normal writing.
{2} "LIGHT": Used for dark writing.
{3} "DARKER": Used for faint writing.
{1} "1 ITEM" (default)
{#}{5}{9}
{2} "ALL ITEMS"
See page 51 for details.
To hear an incoming call from the speaker when the answering
{#}{6}{7}
machine is recording the message.
{0} "OFF"
{1} "ON" (default)
Note:
L You can also program this feature with the cordless handset
(page 38).
L The default code is ";0".
8. Programmable Features
43