Panasonic KX-FC966FX Operating Instructions Manual page 42

8. Programmable Features
Feature
Sending a fax at a
specified time
Setting the Caller ID list
to print automatically
Receiving oversized
documents
Changing the LCD
*2
display contrast
Changing the fax
activation code
42
Code Selection
This feature allows you to take advantage of low-cost calling
{#}{2}{5}
hours offered by your telephone company. This feature can be set
up to 24 hours in advance of the desired time.
{0} "OFF" (default)
{1} "ON"
To send a document:
1. Insert the document.
2. If necessary, press {A} or {B} repeatedly to select the
desired resolution (page 25).
3. {MENU} i {#}{2}{5}
4. Press {1} to select "ON". i {SET}
5. Enter the fax number. i {SET}
6. Enter the transmission start time.
7. {SET} i {MENU}
Note:
L To cancel after programming, press {STOP} then {SET}.
{0} "OFF" (default): The Caller ID list will not be printed
{#}{2}{6}
automatically, but the base unit will keep a record of the
information for the last 50 callers.
{1} "ON": The Caller ID list will be printed automatically each time
the base unit logs 50 callers (page 22).
To slightly reduce the received fax image when printing, so that
{#}{3}{6}
the received document will be approximately the same length as
the original document.
{0} "OFF": Deactivates this feature. The received fax image will
be printed at the same size as the original image.
{1} "ON" (default): The received fax image will be printed slightly
smaller than the original image.
Note:
L A slight margin will be added to the printed documents, and
therefore if this feature is turned OFF, the received document
will be slightly longer than the original document.
{1} "NORMAL" (default)
{#}{3}{9}
{2} "DARKER"
If you wish to use an extension telephone (page 30) to receive
{#}{4}{1}
faxes, activate this feature and program the activation code.
{0} "OFF"
{1} "ON" (default)
1. {MENU} i {#}{4}{1}
2. Press {1} to select "ON". i {SET}
3. Enter your code from 2 to 4 digits, using 0-9, {*} and {#}.
4. {SET} i {MENU}
L If you select 12-hour time entry (page 16), press {*}
repeatedly to select AM or PM.
L If you select 24-hour time entry (page 16), the time is set
using 24-hour time entry.
L The default code is ";#9".