Table of Contents
Advertisement
Auto Setup method when using
a single cable router
When a single cable router is used, it is necessary to
change the settings of this unit and then run Auto Setup.
1
Press [FUNCTION MENU].
2
Select "Setup" in "Others", then press
[OK].
Setup
DVB Tuning
HDD / Disc
Picture
Sound
Display
Connection
Network
Others
OK
RETURN
3
Select "Antenna System" in "DVB
Tuning".
4
Press [2, 1] to select "Single Cable".
DVB Tuning
Favourites Edit
Channel List
Auto Setup
Manual Tuning
Update Channel List
Signal Condition
Antenna System
LNB Configuration
Preferred Language
RETURN
5
Press [3, 4] to select "Auto Setup",
then press [OK].
1 Select "Yes", then press [OK].
2 Select the country, then press [OK].
Single Cable
6
Make the settings of user band.
User Band Settings
Start Auto Setup
Please confirm user band settings before starting Auto Setup.
Tuner 1
User Band
User Band Frequency
User Band PIN
Tuner 2
User Band
User Band Frequency
User Band PIN
Select
OK
RETURN
User Band You can set C1 to C8. Set to a User
Band not used by any other device.
≥When only one User Band of the
Router is assigned, set "Tuner 2" side
to "Off". Note that you will not be able
to record 2 programmes
simultaneously or watch TV during
recording.
User Band
Set the User Band Frequency with
Frequency
number buttons.
User Band
If the single cable router requires a PIN
PIN
to access an user band, enter the PIN.
≥For details, read the manual of the single cable
router, etc.
7
Select "Start Auto Setup", then press
[OK].
8
Select the search mode, then press
[OK].
Auto Setup starts.
These operations (Searching Satellite and Searching
Channels) may take some time.
Auto Setup
Satellite
Checking LNB1
Progress
This will take up to 40 minutes.
Tuner 1
Checking...
Satellite
Press RETURN to skip Satellite installation
Searching Satellite
RETURN
After tuning has been completed, clock will be set
automatically.
If the clock setting screen appears, set the time
manually (
87, Clock).
To set Power Save settings
1 Press [FUNCTION MENU].
2 Select "Setup" in "Others", then press [OK].
3 Select "Standby Settings" in "Others", then press [OK].
4 Select "Power Save in Standby", then press [OK].
5 Refer to page 20, step 5.
To start Network Easy Setting
1 Press [FUNCTION MENU].
2 Select "Setup" in "Others", then press [OK].
3 Select "Network Easy Setting" in "Network", then press
[OK].
4 Refer to page 21.
C1
1284 MHz (preset: 1284 MHz)
Off
C2
1400 MHz (preset: 1400 MHz)
Off
Tuner 2
Checking...
23
VQT3C77
Advertisement
Table of Contents
