Table of Contents
Advertisement
TV screen and video
Screen size is wrong.
Check the "TV Aspect" or "Aspect for 4:3 Video". (
Adjust the aspect ratio setting on TV. Refer to your TV's
operating instructions.
If the 16:9 aspect ratio image is output to a 4:3 TV and
the image will be stretched vertically, set "TV Aspect" to
4:3. (
84)
Check "Aspect for Recording" before recording or file
conversion. (
81)
If you connect to 4:3 TV, set "HDMI Video Format" to
"576p/480p". (
84)
Pictures do not appear with the HD quality
although HD setting was made.
The pictures are output with 576p/480p depending on the
programme.
The screen changes automatically.
If there is no operation for 5 minutes or more, the
displayed screen switches to the other states
automatically (only when the "Screen Saver" is set to
"On"). (
84)
There is a lot of image lag when playing
video.
Set "HD optimizer" in the Picture menu to "Off". (
Set "Audio Delay". (
83)
The images from this unit do not appear on
the TV.
The picture is distorted during play, or video
will not play correctly.
Check the connection and the TV's input settings.
An incorrect resolution is selected in "HDMI Video
Format". Reset the setting as follows:
1 While the unit is on, press and hold [OK], the yellow
button and the blue button on the remote control at
the same time for more than 5 seconds.
– "00 RET" is displayed on the unit's display.
2 Repeatedly press [1] (right) on the remote control or
[Í/I] on the main unit until "04 PRG" is displayed on
the unit's display.
3 Press and hold [OK] on the remote control or
[< OPEN/CLOSE] on the main unit for at least
3 seconds.
Set the item again. (
– When Dolby Digital Plus is not output in bitstream,
select "Yes" in "Default Settings" and make proper
settings. (
88)
84)
77)
84)
The unit's "TV System" setting differs from the TV system
used by the disc now playing. While stopped, keep
pressing [∫] (STOP) and [< OPEN/CLOSE] on the main
unit for 5 or more seconds. The system switches from
PAL to NTSC or vice versa. (
Picture may not be seen when more than 4 devices are
connected with HDMI cables.
Reduce the number of connected devices.
The picture may be distorted or a black screen may
appear between scenes recorded with different aspect
ratios.
DVD-R DL and +R DL discs have two writable layers on
one side. Video and audio may momentarily cut out when
the unit is switching layers.
Set "Deep Colour Output" (
(
85) to "Off".
Sound
No sound.
Distorted sound.
Check the connections or amplifier's settings. (
Press [AUDIO] to select the audio. (
To output audio from a device connected with an HDMI
cable, set "HDMI Audio Output" to "On". (
Cannot switch audio.
You cannot switch the audio if "Digital Audio Output" is
set to "Bitstream" (
83)
84)
85) or "Contents Type Flag"
14, 17)
25, 42)
85)
VQT3C77
93
Advertisement
Table of Contents
