Panasonic Diga DMR-XS400 Operating Instructions Manual page 15

If the TV does not have the HDMI terminal, connect
the TV with the 21-pin Scart cable or Audio/Video
cable ( 16)
≥ Supply power from another device when you use 2 or more devices to
receive satellite broadcast, because this unit does not supply power
when it is turned in standby.
When the unit is not to be used for a long time
To save power, unplug it from the household mains socket.
This unit consumes a small amount of power, even when it
is turned off
[approx. 0.2 W ("Power Save in Standby" is activated)]
About HDMI cable
≥Please use High Speed HDMI Cables that have the HDMI
logo (as shown on the cover).
≥When outputting 1080p signal, please use HDMI Cables
5.0 meters or less.
≥Recommended Panasonic HDMI cable part number:
RP-CDHS15 (1.5 m), RP-CDHS30 (3.0 m), RP-CDHS50
(5.0 m), etc.
≥ The HDMI connection supports VIERA Link "HDAVI Control" (
However, to perform PAUSE LIVE TV (
( 30) for programmes that cannot be received by this unit, you need to
connect a 21-pin Scart cable (
≥ You cannot connect this unit to DVI devices that are incompatible with
HDCP.
Depending on the device, images may not display properly or at all when
connecting with a DVI/HDMI switching cable. (Audio cannot be output.)
≥ If you are connecting to a TV that is only compatible with 2 channel
audio output, audio with 3 channels or more will be down mixed (
and output as 2 channels, even if connecting with an HDMI cable.
(Some discs cannot be down mixed.)
72).
27) and Direct TV Recording
16).
Connect the Set Top Box or video
equipment
This unit's rear panel
VIDEO
L
R
TICAL
AUDIO
T
OUT
Set Top Box or video equipment
≥A 21-pin adaptor is required for AUDIO/VIDEO terminal.
108)
AV1
(TV)

VIDEO

RGB/S VIDEO
AV2
(EXT)

VIDEO

RGB/S VIDEO
21-pin Scart cable
AV
15
VQT3C77