Table of Contents
Advertisement
Broadcast
Digital broadcasts cannot be received.
The dish may not be pointing in the direction of the
satellite. If problem persists consult your local TV aerial
installer.
To receive an encrypted broadcast, a CI module valid for
the broadcast is required.
When you use only one terminal, you may not view
correctly if you connect the satellite cable to the LNB IN 2
terminal.
When you use single cable router, additional settings are
required. (
23)
Picture regularly breaks up on some
channels.
Adjust the aerial reception with "Manual Tuning". (
Picture very infrequently breaks up on some
or all channels.
Electrical atmospheric interference caused by local or
distant lightning storms or heavy rain with wind in "leafy"
locations may cause pictures to break up and audio to
mute or distort momentarily.
The receiver (LNB) of the satellite dish must be suitable
for digital reception.
VIERA Link
VIERA Link doesn't work.
Some functions may not work depending on the version
of "HDAVI Control" of the connected equipment. This unit
supports "HDAVI Control 5" functions.
If the connection for the equipment connected with HDMI
was changed, or if there was a power failure or the plug
was removed from the household mains socket, "HDAVI
Control" may not work.
In this case, change TV (VIERA) setting for "HDAVI
Control" again.
Network
You cannot access this unit from DLNA
compatible equipment on the network.
Check the network connection and the network settings.
(
16, 21, 74, 75, 85)
It may not be possible to connect depending on the types
of the equipment or the status of the equipment.
To reset this unit
To return all the settings to the factory preset
Perform "Shipping Condition" or "Default Settings".
(
88)
To reset the rating level settings
79)
The rating level returns to the factory preset.
1 While the unit is on, press and hold [OK], the yellow
button and the blue button on the remote control at
the same time for more than 5 seconds.
– "00 RET" is displayed on the unit's display.
2 Repeatedly press [1] (right) on the remote control or
[Í/I] on the main unit until "03 VL" is displayed on the
unit's display.
3 Press [OK] on the remote control or
[< OPEN/CLOSE] on the main unit.
– "INIT" is displayed on the unit's display.
97
VQT3C77
Advertisement
Table of Contents
