Panasonic WJ-FS616 Operating Instruction page 9

49. Record Output Connector (REC OUT, VIDEO /
S-VIDEO)
The recording signal for the time lapse VTR is pro-
vided via this connector.
This connector can also be used as multiscreen
output 2 with the specified conditions.
50. Playback Input Connector (PLAY IN, VIDEO/
S-VIDEO)
The playback signal from the time lapse VTR is sup-
plied to this connector.
51. Multiscreen Output Connector (MULTISCREEN)
The video output signal for the multiscreen monitor
is provided via this connector.
52. RS-232C Port (VTR CONTROL, RS-232C)
The VTR control signal for the time lapse VTR is pro-
vided via this connector.
Connecting a PC to this connector will allow you to
remote control the video multiplexer.
53. Remote Output Connector (VTR CONTROL,
REMOTE OUT)
The VTR control signal for the time lapse VTR is pro-
vided via this connector.
You can select on the setup menu whether to have
the VTR control signal supplied from this connector
or the RS-232C Port.
54. Alarm / Remote Control Connector (ALARM /
REMOTE)
This connector accepts the alarm signals from the
associated alarm sensor units and the control sig-
nals from the external system.
55. Power Cord
56. Signal Ground Terminal (SIGNAL GND)
57. Termination Switch (TERM., OFF / ON)
This switch is used to enable termination of the
video multiplexer's data port.
58. Data Ports (DATA, OUT / IN)
These ports are used to exchange control data with
the WV-CU550A System Controller or a PC in a sys-
tem.
-7-