Panasonic WJ-FS616 Operating Instruction page 28

2. Clock Display Setting
This item lets you enable or disable the clock dis-
play on the Multiscreen Monitor.
1. Move the cursor to the CLOCK DISPLAY para-
meter.
2. Select ON or OFF by pressing the LEFT or
RIGHT button. The initial factory setting is ON.
ON: Enables clock display on the monitor
screen.
OFF: Disables clock display on the monitor
screen.
Notes:
• Display position is fixed in the upper right cor-
ner of the Multiscreen Monitor while the camera
picture is displayed in single spot.
• Clock display can not be displayed on the
Multiscreen Monitor while the camera pictures
are displayed in multiscreen mode.
3. Still Display
This item lets you enable or disable display of the
subtitle "STILL" on the Multiscreen Monitor when
the channel is in the still mode.
1. Move the cursor to the STILL DISPLAY para-
meter.
2. Select ON or OFF by pressing the LEFT or
RIGHT button. The initial factory setting is ON.
ON: Enables display of the subtitle "STILL" on
the monitor screen.
OFF: Disables display of the subtitle "STILL"
on the monitor screen.
4. Border Display
This item lets you enable or disable the display of
borders that divide the screen of the Multiscreen
Monitor, or select a border colour.
1. Move the cursor to the BORDER parameter.
2. Select the desired mode or colour by pressing
the LEFT or RIGHT button. The initial factory
setting for the border colour is WHITE.
WHITE: White Border
GRAY: Grey (Gray) Border
BLACK: Black Border
OFF: No Border
5. Camera Display Position Setting
This item lets you select the position where the
camera picture will be displayed on the Multiscreen
Monitor.
1. Move the cursor to DISPLAY POSITION then
press the SET button. The table shown below
appears on the monitor.
1
5
9
13
2. Move the cursor to the desired channel num-
ber by pressing the UP or DOWN button.
3. Select the numbers of the cameras to be dis-
played by pressing the LEFT or RIGHT button.
The pictures of the selected cameras are dis-
played one after another on the monitor
screen.
Note: The number can be assigned directly by
pressing the Camera Number Buttons.
4. Press the SETUP/ESC button to return to the
previous MULTI OUTPUT SETUP menu.
Note: This operation only affects the camera
display positions.
It has no effect on the camera channel,
recording order or sequence order.
6. Sequence Mode
This item lets you select the sequence pattern for
display on the Multiscreen Monitor.
Refer to Sequence Setup on page 31 for more
details.
1. Move the cursor to the SEQUENCE MODE
parameter.
2. Select the desired mode by pressing the LEFT
or RIGHT button. The initial factory setting is
SEQ2.
SEQ1: Spot Sequence
SEQ2: Multi Sequence
SEQ3: Multi Sequence
After finishing the setting, press the SETUP/ESC
button to return to the previous SETUP MENU.
-26-
2 3 4
6 7 8
10 11 12
14 15 16