Panasonic WJ-FS616 Operating Instruction page 14

6. Set the jumper connector, located at the top left of
the board to be installed, to the position shown
below.
Initial State
2 8
1 7
7. Insert the board and confirm that the position is
correct. Then push it in straight.
8. After installing the boards, secure them by tighten-
ing the screws and knobs shown above.
Note: Some settings for the VD2 signal and control
data will be necessary from the setup menu of
the Video Multiplexer.
Compensation/VD2/Data Setup on page 34 for
details.
Jumper Connector
Board Connector
Installed State
2 8
1 7
Refer to Cable
Tally Output Setting
Allows you to use the Alarm Input Terminal as Tally
Output Terminal by changing two internal connec-
tions.
1. Disassemble the video multiplexer as described for
installing the Data Multiplex Boards on page 11.
ALM
10
9
2. Move the two connectors from the ALM side to the
TLY side as shown above.
The relation between the connector numbers and
channel numbers is shown in the table below.
CH9 - CH16
CH1 - CH8
-12-
CN33 CN37
1 10 1
CN32 CN36
1 9 1
TLY
Alarm Input Tally Output
CN33 CN37
CN32 CN36