Panasonic WJ-FS616 Operating Instruction page 12

16. Function Button (FUNCTION)
This button is used to display the VTR playback
picture with the camera pictures on the multiscreen
monitor.
During the setup, this button is used to select the
next page.
17. Auto/Increment Button (AUTO/ + )
This button is used to activate the auto panning
function.
During the setup, this button is used to select the
desired parameter in the setup menu.
18. Home/Decrement Button (HOME/ – )
This button is used to move the camera to the
home position.
During the setup, this button is used to select the
desired parameter in the setup menu.
19. Alternate Button (ALT)
This button, used in combination with certain other
buttons, activates special functions.
20. Multi Screen Selection Button
(MULTI SCREEN SELECT)
This button is used to select the desired multi-
screen to be displayed on the multiscreen monitor,
monitoring the camera picture or VTR playback
picture.
Pressing this button repeatedly will switch the
screen as follows:
Camera Picture:
4 7 9 10 13 16 4 screen segments
VTR Playback Picture:
4 9 16 4 screen segments
21. Electronic Zoom Button (ELE-ZOOM)
This button is used to zoom the picture currently
displayed on the monitor screen.
Note: The above operation is not valid unless multi-
screen output is selected by pressing the (F1)
Function button.
22. Alarm Reset Button (RESET)
This button is used to cancel an active alarm. Press
this button, while the alarm function is activated, to
reset the alarm and return the system to the condi-
tion before the alarm function was activated.
23. Data Ports (DATA, IN/OUT)
These ports are used to exchange control data with
the WJ-FS616 Video Multiplexer.
24. Termination Switch (TERM., ON / OFF)
This switch is used to enable termination of the
controller's data port.
When combined
Multiplexer, set this switch to the "ON" position.
25. Controller Unit Number Switch
(CONTROLLER UNIT NO. 1-8)
This switch is used to identify the unit number of
the System Controller.
When combined
Multiplexer, set this switch to the "0" position.
26. Mode Selection Switches (MODE)
These switches are used to select the mode of the
system controller connected to the video multiplex-
er.
When combined
Multiplexer, set as shown below.
OFF
ON
27. Controller On / Off Switch
(CONTROLLER ON / OFF)
This switch is used to turn the power of the system
controller on or off.
28. Power Cord
-10-
with the WJ-FS616 Video
with the WJ-FS616 Video
with the WJ-FS616 Video
MODE