Konica Minolta BIZHUB PRO 1050P User Manual page 344

Troubleshooting
You cannot print the test print
1
Check the LCD of the main body printer control panel.
– When "Ready to copy" is displayed on the LCD, go to Step 3.
– When a diagnostic message or an error message is displayed on
the LCD, refer to the operating manual of the main body printer
(copier).
– When the LCD is blank, go to Step 2.
2
Press [POWER SAVER ON/OFF] on the control panel.
– When the main body printer is used in the Power Save mode, press
this switch to show the LCD in the Display mode.
3
Try to make a copy.
– When copying is available, go to Step 4.
4
Turn off the copier and wait for 10 seconds, then restart it. Print the test
print again after the print controller is ready.
– Contact your Konica Minolta service representative if you cannot
print the test page after performing the above procedures.
The print setting of a job does not correspond to the result of printing
% Check that the printer setting was not changed.
Cannot select [Duplex]
1
In the case of the PCL printer driver, click [Restore Defaults] of the [Set-
up] tab and [Per Page Setting] tab, and return to the state of default.
2
Check that any item other than [Custom Size] or [Japanese Post Card]
is selected in [Output Tray].
3
Check that [Paper Type] setting is not [Transparency], [Transparency
Interleaving (Blank Sheet)], or [Transparency Interleaving (Printed)].
4
In the case of the PCL printer driver, check that the [Print type] setting
is not [Booklet].
bizhub PRO 1050 Printer Controller
9
9-5