Konica Minolta BIZHUB PRO 1050P User Manual page 316

PPD Printer Driver setting (Mac OS X)
Pile Permission
When another printed document remains in Stacker, gives the permission to
stack the output.
Setting the Pile Permission to OFF allows no pile on the stacker.
When a job the pile of which is not permitted is on the stacker, no pile is
made even if a pile permission is granted.
Tandem Mode
Using two copiers (master copier and sub copier), prints can be made at the
same time under the same printing conditions. When printing a large number
of copies, time required to complete the job can be shortened.
When either one of the two copiers is equipped with a print controller, tan-
dem printing can be performed. When both of the copiers are equipped with
a print controller, the copier which receives the printing job instruction func-
tions as the master copier and the other one is the sub copier.
For the tandem printing, the two copiers should be connected by either
method as follows.
- Connect the two copiers directly with a cross cable. In this case, the net-
work functions cannot be used.
- Connect them with a straight cable via HUB.
Note
Use a cross cable or straight cable higher than the category type 5.
Tandem printing should only be set up by your authorized service repre-
sentative.
Refer to the "User Manual (Copier)" for more information about Tandem
Mode.
bizhub PRO 1050 Printer Controller
8
8-15