Konica Minolta BIZHUB PRO 1050P User Manual page 185

5
Tandem Mode
Using two copiers (master copier and sub copier), prints can be made at the
same time under the same printing conditions. When printing a large number
of copies, time required to complete the job can be shortened.
When either one of the two copiers is equipped with a print controller, tan-
dem printing can be performed. When both of the copiers are equipped with
a print controller, the copier which receives the printing job instruction func-
tions as the master copier and the other one is the sub copier.
For the tandem printing, the two copiers should be connected by either
method as follows.
- Connect the two copiers directly with a cross cable. In this case, the net-
work functions cannot be used.
- Connect them with a straight cable via HUB.
Note
Use a cross cable or straight cable higher than the category type 5.
Tandem printing should only be set up by your authorized service repre-
sentative.
Refer to the "User Manual (Copier)" for more information about Tandem
Mode.
5-36
PPD Printer Driver setting (Windows)
bizhub PRO 1050 Printer Controller