Specifying The Line For Sending (Line Selection) - Konica Minolta BIZHUB C250 Operations

Transmission applications
7.19

Specifying the line for sending (Line selection)

The Fax Multi Line should be installed.
If the Line 2 Setting of the Multi Lines Setting is set to [RX only], no line can
be specified. Refer to page 11-74 for more information on the Multi Lines
Setting.
1
Press [Fax] on the control panel to view the fax screen, if it is not
already displayed.
2
Press [Comm. Setting].
3
Press [Line Setting].
4
Select a line to be used in the [Line Selection].
– If you select [No Selection], a blank line is used.
5
Press [OK].
The Comm. Setting screen will be restored.
bizhub C250 (Phase3)
7
7-51