Cannot Send Messages - Konica Minolta BIZHUB C250 Operations

Troubleshooting
5 Troubleshooting
5.1

Cannot send messages

When a document cannot be sent, try to correct the problem by referring to
the table below. If the document still cannot be sent properly even after
attempting to correct the problem, please contact your service
representative.
!
Detail
Refer to "Error message displayed" on page 5-6 for information
regarding error messages.
Refer to the User manual [Copy Operations] provided with the FK-502 for
problems such as jamming of originals, paper jams, poor image quality
or running out of toner.
Check points
Is the transmission procedure cor-
rect?
Is the fax number of the destination
being called correct? Are program
dialing or abbreviated dialing num-
bers registered correctly?
Is the telephone line setting cor-
rect?
Is the telephone line connected
properly?
Is there a problem with the receiv-
ing machine?
bizhub C250 (Phase3)
Corrective actions
Check the transmission procedure and then try sending
again.
Using program dialing or abbreviated dialing, there may be
an error in registration of the fax number. Try printing out
the Abbreviated Dialing List and check if the number is
registered correctly. Correct if there is an error in registra-
tion.
Does [Dialing Method] of [Telephone Line Settings] in the
Utility Mode match the telephone line being used? Check
the setting and correct if there is an error.
Is the telephone line disconnected? Check the telephone
line connection and connect it if it is disconnected.
Is the power of the receiving facsimile turned off, is it out
of paper or is there another problem? Telephone the des-
tination and check if there is a problem.
5
5-3