3
6
Press [Start].
–
When the Destination Check Display function is set to ON, the
Check Destination screen appears. Then, check the destination to
see if it is correct and press [TX]. Refer to page 7-50 for details.
–
The machine begins to scan the original and transmission starts.
–
The following screen will appear if the TX Result Report Check
screen is programmed to appear. If you want to print the TX Report,
press [Yes].
–
To interrupt transmission, press [STOP].
–
When it can not transmit, see page 5-3.
–
If the transmission fails, TX Report is automatically output (if the TX
Report is programmed to print). For details of Report Settings, see
"Report settings" on page 11-70.
–
For more information about the TX Report, see "TX report" on
page 12-10.
3-6
Transmission
bizhub C250 (Phase3)