To Set The "Specialty Paper" Function - Konica Minolta 8020 User Manual

3.5 Loading Paper
5
Load the paper into the drawer so that the side of the pa-
per to be printed onto (the side facing up when the pack-
age was unwrapped) faces up.
Note
If the paper is curled, flatten it before loading it.
Do not load so much paper that the top of the stack is
higher than the Ä mark.
Paper other than plain paper cannot be fed from the
2nd drawer or optional paper feed units.
If you wish to make copies onto paper other than plain paper, feed it through the manual bypass
tray or the 1st drawer.
When loading additional paper, remove any paper remaining in the drawer, place it on top of the
new paper, and then align the paper in the stack well before loading it into the drawer. If the paper
is not aligned well, a paper misfeed may occur. We recommend replenishing the paper only after
all of the paper in the drawer has been used.
6
Close the paper drawer.
"Specialty Paper" function
The paper loaded into the 2nd, 3rd or 4th drawer can be specified as special paper.
If the paper in a drawer is specified as special paper, the paper in that drawer is not automatically selected
with the Paper setting "Auto Paper". This function is useful if special paper is loaded into a paper drawer.
For more details, refer to "To set the "Specialty Paper" function" of the Administrator Operations volume.

To set the "Specialty Paper" function

1
Press the [UTILITY] key.
2
Touch [User's Choice: 2].
3
Touch [Specialty Paper].
4
Select the paper drawer that you wish to set.
5
Select the desired special paper setting.
Konica 8020/8031
3
3-17