The Program Menu - Kurzweil PC2R Musician's Manual

Descriptions of Parameters
Setup Editor Parameters
Auxiliary Bend 1, Up (AuxBnd1 Up)
Sets the number of semitones of upward pitch bend applied by any physical controller that
sends AuxBnd1 (MIDI 21 for MSB and MIDI 53 for LSB), when that controller is at its maximum.
Auxiliary Bend 1, Down (AuxBnd1 Dwn)
Sets the number of semitones of downward pitch bend applied by any physical controller that
sends AuxBnd1 (MIDI 21 for MSB and MIDI 53 for LSB), when that controller is at its maximum.
Auxiliary Bend 2 Range (AuxBnd2 Rng)
Sets the number of semitones of pitch bend applied by any physical controller that sends
AuxBnd2 (MIDI 15), when that controller is at its maximum. In the default setup, there aren't
any controllers set to send AuxBnd2.

The Program Menu

Bank
When you select this parameter, the top line of the display shows the current zone of the setup
you're editing, as well as the bank ID and program ID of the program assigned to the zone. The
bottom line shows the ID and name of the bank that the current zone uses.
This parameter selects the bank for the current zone. It also determines which bank-select value
the zone sends via MIDI when you select the setup (the zone won't send a bank-select message
to the MIDI Out port if it has a value of Local for the Dest parameter in the MIDI Xmit menu).
Program ID and Name (No parameter name shown)
When you select this parameter, the top line of the display shows the current zone of the setup
you're editing, as well as the bank ID and program ID of the program assigned to the zone. The
bottom line shows the ID and name of the program assigned to the current zone.
This parameter selects the program for the current zone. It also determines which program-
change value the zone sends via MIDI when you select the setup (the zone won't send a
program-change message to the MIDI Out port if it has a value of Local for the Dest parameter
in the MIDI Xmit menu).
Note: When you enter the Program menu, the first parameter you see is the Program ID and
Name parameter. To get to the Bank parameter, press the Left cursor button once.
Entry Transmit
Determines whether the current zone sends a program-change command when you select the
setup. If its value is On, the zone transmits the program ID of the program assigned to the zone
(as shown in the top line of the display when you're viewing this parameter). This is the setting
for each zone in the default setup. The program-change message may include a bank-select
message, depending on the value of the Bank Mode parameter.
If the value of Entry Transmit is Off, the zone doesn't send a program change when you select
the setup.
5-12