Entering An Edit Mode; Finding A Parameter And Changing Its Value - Kurzweil PC2R Musician's Manual

Programming Your PC2R
Basic Editing Concepts

Entering an Edit Mode

There are four buttons that take you into the PC2R's various edit modes:
Edit
FX
MIDI Receive
Global
You can get to Effects edit mode, MIDI receive mode, or Global mode from any performance
mode; just press FX, MIDI Receive, or Global.
To edit programs or setups, you must first select the performance mode corresponding to the
object you want to edit (select KB3 mode, for example, if you want to edit a KB3 program).
When you've selected a performance mode, press Edit.
When you press Edit, you go to the first menu in the edit mode corresponding to the
performance mode you were in when you pressed Edit. You'll see one of the following displays:
Internal Voices mode
KB3 mode
MIDI Setups mode

Finding a Parameter and Changing its Value

To navigate through the PC2R's menus, use the Alpha Wheel or the cursor buttons (the right
and left arrow buttons at the bottom left of the Edit region) and the Enter button.
Notice the arrows (
menus of parameters by pressing the Right cursor button. The reason you don't see any left
arrows in these examples is that when you enter an edit mode, you're always at the top menu.
As soon as you move away from the top menu, you'll see a left arrow in the display as well.
1. Once you've entered an edit mode, use the Alpha Wheel or the cursor buttons to find the
2. Press Enter to enter the menu.
3. Use the cursor buttons to view the parameters in the menu. In most cases, there's just one
4-2
Takes you to the first menu in the edit mode corresponding to the
performance mode you were in.
Takes you to the first FX edit menu corresponding to the current mode.
Takes you to the Channel 1 menu in MIDI Receive mode, where you can
configure each MIDI channel for program and controller assignments.
Takes you to the global three-band EQ, which is actually the first "menu" in
Global mode, which contains parameters for overall control of the PC2R.
Sound|Parameters
||||Timbre|||||>
||KB3|Parameters
||||Timbre|||||>
Zone|Parameters
||||MIDI|Xmit||>
> ) in the display examples above. They indicate that you can view more
menu you want.
parameter visible at a time. In that case, when you see the parameter you want to edit,
turn the Alpha Wheel left or right to change the value.
In some cases, you can see more than one parameter at a time (for example, the global
three-band EQ is a set of three parameters in Global mode). When there's more than one
parameter visible, use the cursor buttons to move the cursor (the little flashing bar) under
the value you want to change. Then turn the Alpha Wheel to change the value.