Other Effects-Mode Functions - Kurzweil PC2R Musician's Manual

Programming Your PC2R
Effects Edit Mode
You don't have to modify the factory programs when editing effects; you can create a new
program in the User bank instead.
1. Repeat Steps 1 and 2 from the preceding procedure. When you see the Save dialog, press
2. Press Yes to save to the current program ID (or rename the program first, as described on
If you've entered Effects edit mode from the User bank of Internal Voices mode, the Save dialog
starts by asking if you want to replace the current effect assignment for the current program (just
as it does for programs in the Internal bank). If you press the Right cursor button, the Save
dialog doesn't jump to the lowest-available program ID in the User bank; it asks you if you want
to replace the current program. Again, you can select a different ID if you want. The dialog says
Save
The Save dialog operates in exactly the same way if you enter Effects edit mode from either the
Internal or User bank in KB3 mode. If you're coming from MIDI Setups mode, the dialog is a bit
different, since setup effects are stored as part of the entire setup, not its constituent programs.
Consequently, the dialog doesn't ask you if you want to replace the current effect; it asks you if
you want to save the setup (if you're coming from the Internal bank) or replace the setup (if
you're coming from the User bank). Otherwise, the Save dialog operates the same as it does for
Internal Voices mode and KB3 mode.

Other Effects-Mode Functions

There's more to Effects-mode Save dialog than just storing the results of your editing. You can
also do the following:
• Dump effects via MIDI System Exclusive messages to an external MIDI recording device
• Restore the factory settings for the effects of the current program (applies to programs in the
Internal bank of Internal Voices mode and KB3 mode; doesn't apply to setups or to
programs in any User bank)
• Restore the factory settings for the effects of all programs in the Internal banks for Internal
Voices mode and KB3 mode (doesn't apply to setups or to programs in any User bank)
We describe all of these procedures in Other Save-Dialog Functions on page 4-4.
4-30
the Right cursor button. The Save dialog changes:
Save|Voice|N?
Digital E Piano
stands for the lowest-available program ID in the User bank for Internal Voices mode. At
N
this point, you can either proceed to the next step, or select a different program ID. If
the ID is unused, the dialog doesn't change. If you select an ID that already has a program
assigned to it, Save changes to
page 4-3).
or Replace depending on whether you select an ID that's already in use.
Replace .