Viewing A List Of Attached Devices - NETGEAR WNR1000v3h2 User Manual

Table 3. Router Statistics
Item
Status
TxPkts
RxPkts
Collisions
Tx B/s
Rx B/s
Up Time
Poll Interval
To change the polling frequency, enter a time in seconds in the Poll Interval field, and
click Set Interval.
To stop the polling entirely, click Stop.

Viewing a List of Attached Devices

The Attached Devices screen contains a table of all IP devices that the router has discovered
on the local network. Select Attached Devices under Maintenance in the main menu to view
the table.
Figure 4.
For each device, the table shows the IP address, NetBIOS host name or device name (if
available), and the Ethernet MAC address. To force the router to look for attached devices,
click Refresh.
Note: If the Wireless Router is rebooted, the table data is lost until the
router rediscovers the devices.
82 | Chapter 6: Using Network Monitoring Tools
Description
The link status of the port.
The number of packets transmitted on this port since reset.
The number of packets received on this port since reset.
The number of collisions on this port since reset.
The current transmission (outbound) bandwidth used on the WAN and LAN ports
(the average bytes per second transmitted since reset). Tx B/s is the total bytes
transmitted divided by the system up time (in seconds).
The current reception (inbound) bandwidth used on the WAN and LAN ports (the
average bytes per second received since reset). Rx B/s is the total bytes received
divided by the system up time (in seconds).
The time elapsed since this port acquired the link.
The intervals at which the statistics are updated in this screen.
N150 Wireless Router User Manual