14.3 PINNING
This selection is used to enable or disable position updates when the vessel
is not underway. The default setting is "on".
1. Press and hold down the
up Menu " appears.
2. Press the
SETUP ".
3. Press the
with the
4. Press the
/
key to select " On " or " Off ".
On : W h e n p i n n i n g i s t u r n e d " o n " , t h e
GX1700 will not update its position
unless the vessel travels over 10Ft.
Off : When the vessel is underway or stopped, the
GX1700 continuously updates its position (unless transmitting). This
improves accuracy of the position fix.
5. Press the
6. Press the
14.4 TIME OFFSET
From the Factory the GX1700 shows GPS satellite time or UTC time. A time
offset is needed to show the local time in your area. The Time Offset must be
changed in order for the radio to display the current time in your area. Refer
to section "6.7 CHANGING THE GPS TIME" for setting.
14.5 TIME AREA
This selection allows the radio to show UTC time or local time with the offset.
Refer to section "6.8 CHANGING THE TIME AREA" for setting.
14.6 TIME DISPLAY
This selection allows the radio to setup to show time in 12-hour or 24-hour
format. Refer to section "6.9 CHANGING THE TIME DISPLAY" for setting.
14.7 MAGNETIC
This selection allows the GPS Course Over Ground to be selected to show
in True or Magnetic. Factory default is True however by following the steps
below the COG can be changed to Magnetic. Refer to section "6.10 CHANG-
ING COG TO TRUE OR MAGNETIC" for setting.
GX1700
/
key to select " GPS
soft key, then select " PINNING "
/
key.
soft key, then press the
soft key to save the new setting.
soft key several times to return to radio operation.
key until " Set-
SELECT
SELECT
-Setup Menu-
GENERAL SETUP
CH Function Setup
DSC Setup
Waypoint Setup
-Setup Menu-
GPS Setup
General Setup
MMSI Setup
CH Function Setup
QUIT
DSC Setup
Waypoint Setup
GPS SETUP
MMSI Setup
SELECT
-GPS Setup-
Unit Power
Coodinate System
PINNING
Time Offset
Time Area
-Pinning-
Time Display
On
QUIT
OFF
ENT
QUIT
QUIT
Page 93