Threading The Upper Thread; Auxilary Spool Pin - Husqvarna Viking Platinum 755 User Manual

Threading the Upper Thread

When threading the upper thread, make
sure that the presser foot is raised and the
needle is in the up position.
1 Pull the spool pin out. Place the spool
on the spool pin with spool holder
(follow the instuctions on previous
page). The thread shall reel clockwise.
Push the spool pin back in.
Hold the thread near the spool using
your right hand. Use your left hand to
bring the end of the thread in the direc-
tion of the arrow on the machine.
2 Bring the thread into the pre-tension
thread guide (a). Bring the thread down
between the thread tension discs (b).
a
b

Auxilary Spool Pin

The auxilary spool pin is used when winding
a bobbin from a second spool of thread or
for a second spool when sewing with a twin
needle.
When using the auxilary spool pin, place the
large spool holder and a felt pad under the
thread spool.
3 Continue threading in the direction indi-
cated by the arrows. Bring the thread
from the right when threading into the
slot on the take-up lever.
4 Pull the thread into the last guide just
above the needle.
5 The needle is threaded from front to
back (see needle threader for further
instructions).
6 Place the thread under the presser foot
and into the thread cutter, pull it down-
wards to cut it.
Learn your Platinum
7