Functions On The Touch Panel; Design Width - Husqvarna Viking Designer topaz 25 User Manual

FUNCTIONS ON THE TOUCH PANEL

10. STITCH MENU/LOAD DESIGN
embroidery stick is inserted to load a design.
11. FONT MENU
12. SHIFT TO UPPER-CASE, LOWER-CASE OR
NUMBERS
Press to shift to lower or upper-case or numbers when
programming letters.
13. PROG (PROGRAM MODE)
Press PROG to open the mode for programming. Press the
button again to exit the program mode.
14. SAVE TO MY STITCHES
Press to open the menu where you can save your own
personal stitches or stitch programs. Press again to exit the My
15. ALT (ALTERNATE VIEW)
When you select a satin stitch the length and width settings
will be shown on the GraphicDisplay. By pressing ALT the
density setting will be shown instead of the length setting.
In embroidery mode, pressing ALT will switch between
embroidery edit and embroidery stitch-out view.
16. STITCH LENGTH/DENSITY AND DESIGN
HEIGHT
In sewing mode, reduce or increase the stitch length/density
by pressing – or +
In embroidery mode, reduce or increase the design height by
pressing – or +
17. STITCH WIDTH/NEEDLE POSITION AND

DESIGN WIDTH

In sewing mode, adjust the stitch width/needle position by
pressing – or +
In embroidery mode, reduce or increase the design width by
pressing – or +
28
15 16
20
31
18. MIRROR SIDE TO SIDE
Press to mirror the selected stitch side to side. In straight
stitch, with a left needle position, pressing this icon will move
the needle from the left to the right symmetrically across
programs, the whole stitch program is mirrored. The change is
visible on the GraphicDisplay and an icon is shown indicating
In embroidery mode, press to mirror the loaded design side to
side. The change is visible on the GraphicDisplay and an icon
19. DELETE
Press to delete a single stitch or all stitches in a stitch program
or embroidery font program. Or use it to delete your saved
10
11
12
13
14
17 18 19
21 22
23
24 25
26 27 28
29 30