Grandstream Networks GXP2110 User Manual page 32

Intercom User ID:
Disable Call Waiting
Disable Call
Waiting Tone
Disable Direct IP Calls
Use Quick IP Call Mode
Disable Conference
Enable MPK Sending
DTMF
Disable DND Button
Disable Transfer
Configuration via
Keypad Menu
Grandstream Networks, Inc.
This field is used to configure the Intercom key in the phone. For GXP2010 and
GXP2020 only
If the phone is working with a GS GXE502X IP-PBX it can be configured in the
following manner:
•
To page an extension : [intercom feature code]+[*]+[extension number]
•
To page a group : [paging group feature code]+[*]+[group extension]
Default is No. If set to Yes, the call waiting feature will be disabled.
Default is No. If set to Yes, the call waiting tone will be disabled.
Default is No. If set to Yes, direct IP calls will be disabled
Dial an IP address under the same LAN/VPN segment by entering the last octet
in the IP address.
In the Advanced Settings page there is an option "Use Quick IP-call mode".
Default setting is No. When set to YES, and #XXX is dialed, where X is 0-9 and
XXX <=255, phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet mask.
#XX or #X are also valid so leading 0 is not required (but OK). See Quick IP
Call Mode for details.
Default is No. If set to Yes, conference will be disabled.
Default is No. If set to "Yes", Muti-Purpose keys can be sent as DTMF.
Default is No. If set to "Yes", the "DND" button on keypad will be disabled.
Default is No. If set to Yes, transfer will be disabled.
Configures the access control of configurations via the phone keypad menu.
There are three modes:
•
Unrestricted
•
Basic Settings Only
•
Constraint Mode
GXP2110 User Manual
Firmware 1.0.0.44
Page 32 of 42
Last Updated: 09/2010