Grandstream Networks GXP2110 User Manual page 29

STUN Server
Firmware Upgrade and
Provisioning
XML Config File
Password
HTTP/HTTPS User Name The user name for the HTTP/HTTPS server.
HTTP/HTTPS Password
Upgrade Via
Firmware Server Path
Config Server Path
Firmware File
Prefix/Postfix
Config File
Prefix/Postfix
Allow DHCP Option 43
and Option 66 to
override server
Grandstream Networks, Inc.
IP address or Domain name of the STUN server. STUN resolution result will
display in the STATUS page of the Web UI.
Allows the user to select the following options for firmware upgrade:
•
Always Check for New Firmware
•
Check New Firmware only when F/W pre/suffix changes
•
Always Skip the Firmware Check.
Firmware upgrade may take up to 10 minutes depending on network
environment. Do not interrupt the firmware upgrading process.
Note: Grandstream strongly recommends that the user upgrade firmware
locally in a LAN environment if using TFTP to upgrade. Please do NOT
interrupt the TFTP upgrade process (especially the power supply) as this will
damage the device.
The password used for encrypting the XML configuration file using OpenSSL.
This is required for the phone to decrypt the encrypted XML configuration file.
The password for the HTTP/HTTPS server.
This field allows the user to choose the firmware upgrade method: TFTP, HTTP
or HTTPS.
Defines the server path for the firmware server. It can be different from the
Configuration server which is used for provisioning.
Defines the server path for provisioning; it can be different from the firmware
server.
Default is blank. If configured, GXP2110 will request the firmware file with the
prefix/postfix and only the firmware with the matching encrypted prefix will be
downloaded and flashed into the phone.
This setting is useful for ITSPs. End user should keep it blank.
Default is blank. If configured, GXP2110 will request the config file with the
prefix/postfix and only the file with the matching encrypted prefix will be
downloaded and flashed into the phone.
This setting is useful for ITSPs. End user should keep it blank.
Default is Yes. This allows device gets provisioned automatically.
GXP2110 User Manual
Firmware 1.0.0.44
Page 29 of 42
Last Updated: 09/2010